Construction
STEP 5: Attach top frame...
|
Position the top frame pieces around the Plexiglas. Use the screwdriver to drive 2 screws vertically down into the corners of each of the frame pieces. Now, all that is left to do is to screw the side panelling on. We recommend about three screws on each of the four sides of each panel. Lots of screws... |
 |
NOTE: While trouble shooting, for purpose of accessing your internal components, leave one side panel off. If desired, you can affix hinges to this panel and create a door. In the BitBox, the door panel has blocks that fit exactly into the frame, and rely on friction (see image in Step 2 "Placement..." of the Hardware section).
NOTE: Optional (though recommended) additions include a cord port and a heat vent, made of an outlet frame and a ventilation frame. In our case, both are affixed to the side panelling using an adhesive called No-More-Nails. However, before you do this, go ahead to the Hardware section to see how to set up your internal components. Then, you can see how everything is set up inside and decide what kind of ports you would like to add, if any.
Continue to Hardware...